Good release effect                                                                  Features

high stability                                                      

No reaction with the casting material

Not corrode the mold

Environment protection and without pollution

1. Remove grease and wax thoroughly with solvent to ensure the mould cavity clean and dry

2. For the new mould, initial using need to spray for 3-4times(After the solvent evaporation and then spray brush again),after that one mould to spray one time or several moulds to spray one time(several moulds to spray one time: normally paint one time after the mould poured 2～10 times)

3. When a thin coating can be formed on the surface of the mold cavity by the method of spraying or brushing, then it is ok

Process

Performance parameters

Aspect

Unit

Value

colour and lustre

—

Transparent liquid

Viscosity

mPa.s

15

Flash point

℃

65

Spread rate

㎡

20-25

Density

g/mm³

0.90-0.92